precision machining

Scan! Add WhatsAPP

precision machining

Scan! Add WeChat

Assembly technical requirements

1. When assembling the hydraulic system, it is allowed to use seal packing or sealant, but it should be prevented from entering the system.

2. The parts and components (including purchased parts and outsourcing parts) that enter the assembly must have


1. When assembling the hydraulic system, it is allowed to use seal packing or sealant, but it should be prevented from entering the system.

2. The parts and components (including purchased parts and outsourcing parts) that enter the assembly must have the certificate of the inspection department before they can be assembled.

3. The parts must be cleaned and cleaned before assembling. There must be no burrs, flashes, oxide skins, rust, chips, oil stains, colorants and dust.

4. Before assembling, recheck the main matching dimensions of parts and components, especially the interference fit dimensions and related accuracy.

5. The parts are not allowed to knock, bump, scratch and rust during the assembly process.

6. When assembling the taper pin, the hole should be painted and checked, and the contact rate should not be less than 60% of the mating length, and should be evenly distributed.

7. The number of tooth surfaces contacted by the spline assembly at the same time shall not be less than 2/3, and the contact rate shall not be less than 50% in the length and height of the key teeth.

8. After the flat key (or spline) with sliding fit is assembled, the relative parts can move freely without unevenness of tightness.

9. Before assembling, all pipes should be free of flashing, burrs and chamfering. Use compressed air or other methods to remove debris and rust attached to the inner wall of the pipe.

10. Before assembly, all steel pipes (including prefabricated pipes) must be degreasing, pickling, neutralization, water washing and anti-rust treatment.

11. When assembling, tighten the pipe clamps, supports, flanges and joints to prevent loosening.

Latest news and stories

machining customization
05-11

Principles of cnc parts machining customization

In the field of mechanical machining, the main content of the process route is to rationally arrange […]

machining custom process
05-11

CNC accessories machining custom process

First of all, before customizing CNC parts machining, you must see the content of the process clearl […]

non-standard customization
05-11

What are the advantages of CNC non-standard customization?

Nowadays, CNC non-standard processing technology is becoming more and more popular in all major indu […]